Crack Injection
| Low pressure crack injection with Leakmaster epoxies and foams allows for superior repairs with less investment in time and tools compared to high pressure injection. The low pressure system enables injection material to flow completely to all parts of the crack without "backing-up." The surface mounted injection ports are mounted to the pool surface directly over the crack using the same epoxy that seals the surface of the crack. No drilling is required. For added reinforcement use Carbon Fiber Staples to spread load and prevent future cracking. | ||
|
|
|
| Mix a portion of Surface Seal epoxy and apply to the back of injection port. | Attach injection ports to pool surface over the crack. Ports should be spaced every 6-8". | Apply Surface Seal over the flange of injection ports and along the length of the crack. |
|
|
|
| Inject foam or epoxy into crack using "Jake" continuous pressure gun. Start at lowest port, cap port and move to next when material flows from port above. | After injection material has cured use a hand grinding wheel remove Surface Seal and injection ports. | "V-cut crack and apply plaster repair product to finish job. Crack will be sealed all the way through pool wall. |